TM 5-3895-373-34
A.
REMOVE - Continued.
3.
REMOVE PUMP DRIVE GEARBOX FROM
ENGINE.
NOTE
Adapter gear sleeves (13) may stay
attached to propulsion pump during
propulsion pump removal.
a.
Remove adapter gear sleeves (13).
Pump
drive
gearbox
weighs
approximately
150
lbs
(68
kg).
Ensure cribbing is beneath pump
drive
gearbox
prior
to
removal.
Equipment damage and personnel
injury could result from dropping the
pump drive gearbox when removing
from engine.
b.
Remove hex head cap screws (14) and
lockwashers (15). Discard lockwashers.
c.
Remove self-locking hex nuts (16), flat
washers (17), and pump drive gearbox
support brackets (18). Discard self-locking
hex nuts.
d.
Place two pieces of cribbing beneath pump
drive gearbox, on either side of elbow (12).
GO TO NEXT PAGE
2-381
