TM 5-3895-373-34
2.25
REPAIR STARTER ASSEMBLY - Continued
A.
DISASSEMBLE - Continued.
3.
REMOVE ARMATURE SUPPORT, SHIFT LEVER,
AND DRIVE SHAFT FROM DRIVE HOUSING.
a.
Remove screws (26 and 27).
b.
Pull armature support (28) from drive housing
(29).
NOTE
Washers and spacers may stick to
armature support or assembled drive
shaft
when
armature
support
is
removed from drive housing.
Spacers are factory installed and
quantity may vary from none to
several.
c.
Remove washers (30 and 31) and spacers (32),
keeping washers and spacers in order as they
are removed. They should be reinstalled in the
same order as they were removed.
d.
Pry out housing plug (33) and plate (34) with a
large flat-blade screwdriver.
e.
Remove hex nut (35), lockwasher (36), washer
(37), and screw (38). Discard lockwasher.
f.
Pull assembled drive shaft (39) and shift lever
(40) from drive housing (29).
g.
Pull shift lever (40) from assembled drive shaft
(39).
GO TO NEXT PAGE
2-340
