TM 5-3895-373-34
2.25
REPAIR STARTER ASSEMBLY - Continued
A. DISASSEMBLE - Continued.
Do not allow dowel pin (10) to
become misplaced from frame and
brush
assembly.
Dowel
pin
is
required for assembly and must not
be lost. Use a piece of tape and
attach dowel pin to frame and brush
assembly. Equipment damage may
result from loss of dowel pin.
g.
Remove frame and brush assembly (8) and
dowel pin (10). Attach dowel pin to frame and
brush assembly with a piece of tape.
Use
caution
when
removing
preformed packing (11). Preformed
packing is not procurable separately.
If damaged, order drive housing.
h.
Use an o-ring tool to remove preformed packing
(11).
NOTE
Armature may come off with frame
and brush assembly or may remain
with drive housing. Bearings must
not be removed from armature during
disassembly.
i.
Pull armature (12) from frame and brush
assembly (8) or drive housing (13) with bearings
intact.
j.
Remove screws (14) and lockwashers (15).
Discard lockwashers.
k.
Disconnect solenoid (2) by tilting end of solenoid
down so that drive pin disengages from shift
lever. Remove solenoid from drive housing (13).
GO TO NEXT PAGE
2-338
