TM 5-3895-373-34
2.25
REPAIR STARTER ASSEMBLY - Continued
D.
REPAIR.
1.
REMOVE AND REPLACE SLEEVE BEARING IN
DRIVE HOUSING.
a.
Place drive housing (29) with sleeve bearing (46)
facing up on a hydraulic press frame.
b.
Use adapter (Item 2, Appendix D) to press out
sleeve bearing (46). Discard drive end sleeve
bearing.
c.
Place new sleeve bearing (46) on top of drive
housing (29).
d.
Use adapter (Item 2, Appendix D) to press
sleeve bearing (46) into drive housing (29).
Press until bottom of sleeve bearing is flush with
inside of drive housing.
GO TO NEXT PAGE
2-344
