TM 5-3895-373-34
A.
DISASSEMBLE.
1.
REMOVE MOTOR LEAD, FRAME AND BRUSH
ASSEMBLY, ARMATURE, AND SOLENOID FROM
DRIVE HOUSING AND ARMATURE ASSEMBLY.
a.
Remove hex nut (1) from solenoid (2).
b.
Disconnect motor lead (3). Make a note which
terminal the motor lead is connected to for use
during installation.
c.
Install hex nut (I) back on solenoid.
d.
Remove screws (4 and 5) and preformed
packing (6). Discard preformed packing.
Use
caution
when
removing
commutator end frame. Terminal
lead wires may be damaged from
excessive
force
when
removing
commutator end frame from starter.
Do not use excessive pulling force
during removal of commutator end
frame.
e.
Use a flat blade screwdriver to gently and evenly
pry commutator end frame (7) from frame and
brush assembly (8).
f.
Use an o-ring tool to remove o-ring (9). Discard
commutator end frame o-ring.
GO TO NEXT PAGE
2-337
