TM 5-3895-373-34
D.
REPAIR - Continued.
2.
REMOVE AND REPLACE BEARING ON DRIVE
SHAFT.
a.
Place an adapter (Item 3, Appendix D) beneath
drive shaft (45), with internal gear end of drive
shaft facing up.
b.
Place drive shaft (45) on a hydraulic press
frame.
c.
Place shaft bearing removal tool through holes in
wide end of drive shaft (45).
d.
Press bearing (47) from drive shaft (45).
Discard annular ball bearing.
e.
Remove drive shaft (45) from adapter.
f.
Place drive shaft (45) with splined end facing up
on hydraulic press frame.
g.
Place new bearing (47) over splined end of drive
shaft (45).
h.
Place an adapter (Item 4, Appendix D) over
inner race of bearing (47).
i.
Press bearing (47) onto drive shaft (45) until
seated against wide end of drive shaft.
GO TO NEXT PAGE
2-345
