TM 5-3895-373-34
C.
ASSEMBLE - Continued.
2.
INSTALL ASSEMBLED SHAFT AND SEAL INTO
BODY.
a.
Place bearing body (2) on spacer blocks on
hydraulic press frame.
b.
Press assembled shaft (5) into bearing body
until seated inside bearing body.
Use care when installing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
c.
Use snap ring pliers and install snap ring (1)
into bearing body (2).
3.
INSTALL SEAL INTO BEARING BODY.
a.
Apply a light coating of grease to water pump
shaft (11).
b.
Press seal (6) over shaft into bearing body
using firm finger pressure. If necessary use a
spacer from the universal puller kit and a
plastic hammer to seat seal into bearing body.
Only light taps with the hammer should be
used.
GO TO NEXT PAGE
2-323
