TM 5-3895-373-34
E.
ASSEMBLE - Continued.
19.
INSTALL HEX HEAD CAP SCREWS, CAP
NUTS, SLEEVE, WIRE ROPE, SPRINGS, AND
LEVERS ONTO FUEL INJECTION PUMP.
a.
Install washer (37) and hex head cap
screws (36 and 35) onto control cover (44)
and tighten.
b.
Install flat washer (42), nut (41), and hex
head cap screw (40) and tighten.
c.
Install wire rope (38) onto sleeve (39). Do
not permanently attach wire rope until fuel
injection pump testing is completed.
d.
Install sleeve (39) over hex head cap screw
(40), with wire rope (38) loose.
e.
Install washers (34) and cap nuts (33).
f.
Install throttle, lever (26) and secure with
hex head cap screw (25), lockwasher (24),
and hex nut (23).
g.
Install governor cap (22), lever (21),
lockwasher (20), and hex nut (19).
h.
Install governor cap (31), spring (30),
governor lever (29), lockwasher (28), and
hex nut (27).
i.
Install wire rope (32) onto cap nuts (33). Do
not permanently attach wire rope until fuel
injection pump testing is completed.
j.
Install spring (18) onto governor lever (29)
and throttle lever (26).
k.
Remove fuel injection pump (16) from jig.
20.
INSTALL FUEL SHUTOFF SOLENOID PER
TM 5-3895-373-20.
GO TO NEXT PAGE
2-283
