TM 5-3895-373-34 F. TEST - Continued. b. Screw  transfer  pressure  adjuster   fully   out and then 1-1/2 turns in before starting test. TEST OPERATION RPM REQUIREMENTS Priming 100 max Obtain fuel delivery from all injectors. Transfer pressure 100 8 lb-ft (0,5 bar) minimum. Advance setting 800 Adjust transfer pressure screw to obtain advance of 2.5°. Transfer pressure 800 56 to 72 lb-ft (3,9 to 5,0 bar). Full advance 1400 4.75° to 5.25°. Back leakage 800 20 to 70 cm³ per 100 strokes time cycle.  (Flow rate of 160 to 560 m1/minute.) Maximum delivery setting 1300 Record average delivery in cm³ (spring position code 4). Governor setting 1450 Set throttle by maximum speed adjustment screw to obtain maximum average delivery of 2,0 cm³.  No line to exceed 3,0 cm³.  Lock stop screw. Delivery check 1300 With throttle set same as governor setting test, delivery not to be less than at maximum delivery setting test, minimum 0,4 cm³. Cutoff operation 200 Average delivery not to exceed 0,8 cm³.  Shutoff lever closed. Throttle operation 200 Average delivery not to exceed 1,0 cm³.  Throttle lever closed. GO TO NEXT PAGE 2-285