TM 5-3895-373-34
E.
ASSEMBLE - Continued.
13.
INSTALL END PLATE ASSEMBLY, BANJO
BOLTS, AND FLUID PASSAGE BOLTS ONTO
FUEL INJECTION PUMP.
a.
Position end plate assembly (87) onto fuel
injection pump by aligning spring pin on end
plate assembly with notch in transfer pump
liner (102).
b.
Install end plate assembly (87) and clamp
(86) onto fuel injection pump and secure
with hex head cap screws (85). Tighten to
45 lb-in (5 N•m).
c.
Tighten boss coupling (88) to 450 lb-in (51
N•m).
d.
Install banjo bolts (81 and 83), flat washers
(82), and fluid passage bolt (84) onto fuel
injection pump. Refer to illustration for bolt
positioning.
e.
Tighten banjo bolts (81) to 240 lb-in (27
N•m).
GO TO NEXT PAGE
2-279
