TM 5-3895-373-34
2.19
REPLACE/REPAIR FUEL INJECTION PUMP - Continued.
E.
ASSEMBLE - Continued.
17.
INSTALL SPRING, SPRING HOLDER, AND
SPRING,
AND
ATTACH
SPRING
TO
THROTTLE SHAFT.
a.
Assemble spring (51) and spring holder (50)
through second hole in spring link (60)
plate. Refer to illustration.
b.
While
holding
spring
holder
(50),
compressed, through spring link plate,
install spring (49). Release spring holder
(50).
c.
Hold spring (49) and insert hooked end of
spring through second hole in throttle shaft
(43).
18.
INSTALL
GASKET,
THROTTLE
SHAFT,
SHUTOFF SPINDLE, AND CONTROL
COVER ONTO FUEL INJECTION PUMP.
a.
Install gasket (46) onto top face of fuel
injection pump, with gasket tabs inserted
into slots on governor arm assembly (58).
b.
Install protective cap from DPA tool kit over
throttle shaft (43).
c.
Lubricate seals (48 and 45) with clean
calibrating fluid.
d.
Install seals (45) onto throttle shaft (43).
e.
Install throttle shaft (43) through control
cover (44).
f.
Remove protective cap from throttle shaft
(43) and install onto shutoff spindle (47).
g.
Install seals (48) onto shutoff spindle (47).
h.
Install shutoff spindle (47) through control
cover (44), with arm turned toward nearest
outer edge of control cover.
i.
Remove protective cap from shutoff spindle
(47).
j.
Seat control cover (44) onto shouldered
studs (55) and align with gasket (46).
GO TO NEXT PAGE
2-282
