TM 5-3895-373-34
2.19
REPLACE/REPAIR FUEL INJECTION PUMP - Continued.
B.
DISASSEMBLE Continued.
10.
REMOVE ACCESS COVER AND FUEL
CONNECTION.
a.
Cut and remove wire rope (113). Discard wire
rope.
b.
Remove screw (114), lockwasher (115), access
cover
(116),
and
gasket
(117).
Discard
lockwasher and gasket.
c.
Remove fuel connection (118) and flat washer
(119).
11.
REMOVE PUMP IMPELLER, GOVERNOR HUB,
PUMP PLATE ASSEMBLY, ROLLER SHOES, AND
ROLLERS
FROM
OUTER
ROTOR
HEAD
ASSEMBLY.
a.
Place outer rotor head assembly (111) on bench.
b.
Remove pump impeller (105).
c.
Use a spanner wrench from DPA tool kit to hold
governor hub (120).
d.
Loosen drive screws (121) with an adapter from
DPA tool kit. Do not remove drive screws.
e.
Remove governor hub (120).
f.
Remove pump plate assembly (122), roller
shoes (123), and rollers (124).
g.
Place roller shoes (123) and rollers (124) in a
bath of clean calibrating fluid.
GO TO NEXT PAGE
2-258
