TM 5-3895-373-34
2.74
REPLACE MAIN SCREED VIBRATOR COMPONENTS - Continued
D.
INSTALL Continued.
k
Thread lubrication fitting (27) into place on
internal spline yoke (20). Tighten fitting until
snug.
l.
Lubricate splines of external spline yoke (19)
with a coating of grease.
m.
Press internal spline yoke (20) and external
spline yoke (19) together.
2.
INSTALL BEARINGS ON BEARING PLATE AND
MOTOR MOUNT.
a.
Evenly tap bearings (17 and 18) into motor
mount (7) and bearing plate (12) using a plastic
hammer.
Use care when installing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
b.
Install retaining ring (16) into motor mount (7)
using snap ring pliers.
GO TO NEXT PAGE
2-1064
