TM 5-3895-373-34
A.
REMOVE - Continued.
2.
REMOVE BEARINGS FROM MOTOR MOUNT
AND BEARING PLATE.
Use care when removing or installing
snap and retaining rings. Snap and
retaining
rings
are
under
spring
tension and can act as projectiles
when
released
and
could
cause
severe eye injury.
a
Remove retaining ring (13) from motor mount (3)
using snap ring pliers. Discard retaining ring.
b.
Remove bearing (14) from motor mount (3)
using an internal bearing puller from universal
puller kit.
c.
Remove bearing (15) from bearing plate (8)
using an internal bearing puller from universal
puller kit.
B.
CLEAN.
1.
CLEAN ALL METAL PARTS.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93, 3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Clean all metal parts except bearings in cleaning
solvent. Remove hard deposits with a cleaning
brush.
b.
Wipe off bearings with a lint-free cloth.
GO TO NEXT PAGE
2-1069
