TM 5-3895-373-34
E.
ASSEMBLE Continued.
b.
Place shaft seal bullet (96) over shaft portion of
shaft coupling assembly (92).
c.
Position motor end cap (86) onto shaft seal
bullet (96).
Do not cut or distort shaft face seal during
motor end cap installation. A damaged or
improperly installed shaft face seal may
cause internal lubrication loss and damage
to internal parts.
d.
Install motor end cap (86) over shaft seal bullet
(96) with a twisting motion to prevent damage to
seals. Use care to avoid cutting or distorting
seals.
e.
Remove shaft seal bullet (96).
f.
Insert key (84) in keyway on shaft.
Hydraulic oil can be moderately flammable
and can be an irritant to the skin, eyes, and
respiratory
system.
Avoid
prolonged
exposure. Eye protection and rubber
gloves must be worn when working with
hydraulic oil.
g.
Lubricate threads of hex head cap screws (85)
with clean hydraulic oil.
Improper
tightening
of
fasteners
can
damage
equipment
and
fasteners.
Tightening
hex
head
cap
screws
in
improper
sequence,
or
at
values
not
incremental can damage motor end cap and
cap screws. Tighten cap screws only as
specified.
h.
Install and tighten finger tight hex head cap
screws (85) through motor end cap (86) and into
bearing housing (87).
GO TO NEXT PAGE
2-989
