TM 5-3895-373-34
E.
ASSEMBLE.
1.
LUBRICATE AND INSTALL BEARING HOUSING
SHAFT FACE SEAL.
a.
Place bearing housing (87) on smooth flat
surface with large diameter end of housing up.
b.
Align small chamfered end of shaft face seal tool
(Item 16, Appendix C) (94) with seal seat in
bearing housing.
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
c
Apply clean hydraulic oil to shaft face seal (93).
b.
Install small diameter end of shaft face seal (93)
into bore of shaft face seal tool (95).
e
Insert shaft face seal tool (Item 17, Appendix C)
(95) with shaft face seal (93) into bore of shaft
face seal tool (Item 16, Appendix C) (94).
Do not damage shaft face seal during
installation. Ensure shaft face seal is
seated properly. A damaged or
improperly installed shaft face seal
may cause internal lubrication loss
and damage to internal parts.
f.
Rotate and push shaft face seal tool (Item 17,
Appendix C) (95) until shaft face seal (93) seats
at bottom of bearing housing (87).
g.
Remove shaft face seal tool (Item 17, Appendix
C) (95) and shaft face seal tool (Item 16,
Appendix C) (94).
GO TO NEXT PAGE
2-987
