TM 5-3895-373-34
E.
ASSEMBLE - Continued.
NOTE
Installation at this point involves procedures
that result in timing the auger/conveyor
motor. Timing determines the direction of
rotation of the output shaft. Components
involved in motor timing are gear set, valve
drive shaft, valve plate, and valve.
7.
ALIGN AND INSTALL GEAR SET ONTO
BEARING HOUSING AND SHAFT ASSEMBLY.
Hydraulic oil can be moderately flammable
and can be an irritant to the skin, eyes, and
respiratory
system.
Avoid
prolonged
exposure. Eye protection and rubber gloves
must be worn when working with hydraulic
oil.
a.
Apply clean hydraulic oil to preformed
packings (80) and install in case drain
packing grooves on gear set (79).
b.
Locate largest open pocket between gear
and rollers in gear set (79).
c.
Use a grease pencil and mark this location
of pocket on outside edge of gear set (79).
d.
Align case drain port and pressure relief
port of gear set (79) with case drain port
and pressure relief port of bearing housings
and shaft assembly (83).
e.
Install gear set (79) onto bearing housing
and shaft assembly (83) using alignment
studs (97).
8.
INSTALL VALVE DRIVE SHAFT INTO GEAR
SET.
a.
Fill
auger/conveyor
motor
with
clean
hydraulic oil.
b.
Install valve drive shaft (78) into gear set
(79).
GO TO NEXT PAGE
2-991
