TM 5-3895-373-20
14.2.
REPLACE BURNER AND FUEL SPRAY FUEL PUMP AND MOTOR - Continued.
B.
INSTALL - Continued.
4.
INSTALL COVER PLATE.
a.
Install cover plate (9) onto fuel pump and
motor assembly (12). Secure with three
machine screws (6) and lockwashers (7).
One cover plate screw will not be installed
at this time.
b.
Position lead wire (8) over remaining cover
plate (9) hole and secure with machine
screw (6) and lockwasher (7).
WARNING
Electrical insulating varnish fumes
can be harmful if inhaled. Use only in
a
well
ventilated
area.
Avoid
prolonged exposure to fumes. If
personnel become dizzy or drowsy
during use, get immediate medical
attention.
c.
Apply electrical insulating varnish to lead
wire (8) and machine screw (6).
5.
REPLACE TOOLBOX (1).
NOTE
FOLLOW-ON-TASKS:
Close rear top right access door per TM 5-3895-373-10.
Bleed screed fuel system per paragraph 2.23.11.
END OF TASK
14-8