TM 5-3895-373-2014.2.REPLACE BURNER AND FUEL SPRAY FUEL PUMP AND MOTOR - Continued.B.INSTALL - Continued.2.INSTALL MOTOR.a.Place coupling body (17) onto motor (14)shaft. Make sure that coupling body setscrew (16) aligns with flat on motor shaft;tighten set screw.b.Insert neoprene insert (18) into couplingbody (17).WARNINGThread locking compound solventcan cause eye damage. Wear safetygoggles/glasses when using. Avoidcontact with eyes. If solvent contactseyes, flush eyes with water and getimmediate medical attention.c.Clean threads of motor (14) studs withthread locking compound solvent. Drythreads with lint-free cloth.WARNINGThread locking compound can causeeye damage. Wear safetygoggles/glasses when using. Avoidcontact with eyes. If compoundcontacts eyes, flush eyes with waterand get immediate medical attention.d.Apply thread locking compound (Item 13,Appendix C) to threads of motor (14) studs.e.Position motor (14) onto mounting bracket(15). Make sure motor wiring is positionedas shown. Rotate coupling body (17) byhand to align neoprene insert (18) with fuelpump coupling body. Secure motor tomounting bracket with hex nuts (13).Tighten hex nuts.f.Visually inspect coupling bodies (17 and 23)and neoprene insert (18) to ensurecomplete engagement of components. Ifnecessary, loosen set screws (16 and 22)to adjust properly.GO TO NEXT PAGE14-6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
