1. REMOVE FUEL PUMP AND MOTOR ASSEMBLY

14.2. REPLACE BURNER AND FUEL SPRAY FUEL PUMP AND MOTOR

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
954

TM 5-3895-373-20 A. REMOVE. NOTE Fuel pump and motor may be replaced individually. If replacing these items individually, it is not necessary to disassemble the complete fuel pump and motor assembly. 1. REMOVE FUEL PUMP AND MOTOR ASSEMBLY. a. Remove toolbox (1). b. Disconnect electrical connector (2). Fuel is very flammable and can explode easily. To avoid serious injury or death: Always wear safety glasses/goggles at all times. Keep fuel away from open flame or any spark (ignition source). Keep at least a B-C fire extinguisher within easy reach when working with fuel or on a fuel system. Do not work on fuel system when engine is hot; fuel can be ignited by a hot engine. Post signs that read "NO SMOKING WITHIN 50 FEET" when working with open fuel lines or fuel tanks. c. Place machinery wiping towel below elbows (3 and 4). Tag and disconnect hoses (5) from elbows. Plug hoses with protective caps. d. Wipe up any spilled fuel with machinery wiping towel. Dispose of towel in accordance with local procedures. e. Remove machine screw (6) and lockwasher (7) securing lead wire (8). Discard lockwasher. f. Remove remaining machine screws (6) and lockwashers (7). Remove cover plate (9). Discard lockwashers. g. Remove hex head cap screws (10) and lockwashers (11). Remove fuel pump and motor assembly (12). Discard lockwashers. GO TO NEXT PAGE 14-3

Privacy Statement
Press Release
Contact