TM 5-3895-373-20
B.
INSTALL- Continued.
3.
INSTALL STACK VALVE ELECTRICAL COIL.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
III cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel. If personnel
become dizzy while using cleaning
solvent, immediately get fresh air and
medical help. If solvent contacts skin
or clothes, flush with cold water. If
solvent contacts eyes, flush eyes
with water and get immediate medical
attention.
a.
Wipe off electrical coil armature (16) with a lint-
free cloth and cleaning solvent.
Thread locking compound solvent
can cause eye damage. Wear safety
goggles/glasses when using. Avoid
contact with eyes. If solvent contacts
eyes, flush eyes with water and get
immediate medical attention.
b.
Clean threads of electrical coil armature (16)
with thread locking compound solvent.
c.
Install electrical coil (17) onto electrical coil
armature (16).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
d.
Apply thread locking compound to threads of
electrical coil armature (16).
e.
Install hex nut (15) onto electrical coil armature
(16). Tighten to 14 Ib-in (1,6 N•m).
GO TO NEXT PAGE
13-33
