TM 5-3895-373-2012.3.REPLACE EQUIPMENT DATA PLATES - Continued.B.INSTALL - Continued.3.INSTALL DRIVE SCREW MOUNTED DATAPLATE.a.If drive screw mounting holes are already atdata plate mounting location, skip steps bthrough d.b.Using replacement data plate as atemplate, transfer location of data plateholes to mounting surface on pavingmachine.c.Using hammer and prick punch, centerpunch location for drilling of each drivescrew mounting hole.WARNINGMetal chips from drilling operationcan cause severe eye damage. Wearsafety goggles/glasses when usingportable drill.d.Use a #46 drill from twist drill set and installin portable electric drill. Drill 1/4 in. (6 mm)deep hole at each drive screw mountinglocation. At thin wall mounting locations,drill through panel.e.If data plate has an adhesive backing, peeloff backing paper.f.Line up data plate with drive screwmounting holes in paving machine. Ifequipped with an adhesive backing, pressdata plate onto mounting surface.g.Insert leading end of drive screw in dataplate mounting hole. Tap drive screws, oneat a time, into mounting holes. Make surehead of each drive screw is flush againstface of data plate.END OF TASK12-14
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
