TM 5-3895-373-20
12.3.
REPLACE EQUIPMENT DATA PLATES - Continued.
A.
REMOVE.
1.
REMOVE TACK MOUNTED DATA PLATE.
a.
Use diagonal cutting pliers and remove
tacks.
NOTE
Drive screws are used to install
equipment data plate(s) after tacks
are removed.
b.
If data plate is adhesive backed, use putty
knife
to
scrape
remaining
data
plate
material from paving machine.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
m cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
c.
If necessary, use cleaning cloths and
cleaning
solvent
to
remove
adhesive
residue from data plate mounting surface.
GO TO NEXT PAGE
12-10
