TM 5-3895-373-20
A.
REMOVE.
1.
REMOVE OPERATOR CONTROL CONSOLE
AND GUIDE SHAFT.
a.
Center operator control console (1) on
guide shaft (2).
b.
Lock control console brake (3) to keep the
operator control console from shifting.
c.
With the help of two persons, support
operator control console and guide shaft
and remove hex head cap screws (4),
washers (5), and clamp caps (6 and 7).
WARNING
The operator control console and
guide shaft weigh approximately 200
lbs (90 kg). To avoid personal injury,
use a hoist or get assistance when
lifting the control console and shaft.
CAUTION
Ensure gauge and switch panels on
operator control console are not
damaged
during
control
console
removal. Position control console on
operator platform to ensure gauge
and
switch
panels
cannot
be
damaged.
d.
Lift operator control console (1) and guide
shaft (2) off of console supports (8 and 9)
and place them onto the operator platform.
e.
Loosen control console brake (3) and slide
guide shaft (2) out of operator control
console (1).
f.
Remove bumpers (10) from clamp caps (6
and 7).
GO TO NEXT PAGE
11-35
