j. Unlock and slide operator control console

2. INSTALL OPERATOR CONTROL CONSOLE AND GUIDE SHAFT

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
884

TM 5-3895-373-20 11.4. REPLACE OPERATOR CONTROL CONSOLE SUPPORT FRAME - Continued. B. INSTALL - Continued. j. Unlock and slide operator control console (1) from side to side completely across the entire length of console mounting frame (11). Check to ensure that there is no binding of movement and that a 1/4 in. (6,4 mm) gap is maintained between roll stop bracket (24) on the control console and the console mounting frame. k. If adjustments to the 1/4 in. 6,4 mm) gap need to be made, loosen self-locking hex nuts (12 and 16) and adjust positioning of console mounting frame using a plastic hammer. I. Snug self-locking hex nuts (12 and 16) and check operator control console (1) alignment with console mounting frame (11). Continue to adjust alignment until no binding is found and a 1/4 in. (6,4 mm) gap is maintained for full travel of the control console. m. Tighten self-locking hex nuts (12 and 16) to 90 lb-ft (122 N•m). NOTE FOLLOW-ON-TASKS: Install left access cover per TM 5-3895-373-10. Install right access cover per TM 5-3895-373-10. END OF TASK 11-40

Privacy Statement
Press Release
Contact