TM 5-3895-373-207.20.REPLACE BATTERY CABLES - Continued.B.INSTALL - Continued.2.INSTALL SLAVE CABLES.a.Refer to illustration and install slave cable(29) into paving machine as follows: startingat starter, bring slave cable across back ofengine over flywheel housing. Run cableacross the top of the fuel tank and hydraulicreservoir under the valve panel. Bring theslave receptacle end of the cable throughthe hydraulic hose access slot in the lefthand valve panel and up to the slavereceptacle.b.Install clamp (40) on slave cable (29).c.Install clamp on engine flywheel housingand secure with lockwasher (39) and capscrew (38). Tighten cap screw to 42 lb-ft(57 N•m).NOTETie wraps are located as needed.d.Refer to illustration and install tie wraps (41)on slave cable (29).GO TO NEXT PAGE7-150
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
