TM 5-3895-373-20
B.
INSTALL - Continued
6.
INSTALL FUEL PRESSURE TRANSMITTER
AND
FUEL
FILTER
DIFFERENTIAL
PRESSURE SWITCH.
Pipe sealant can cause eye damage
or skin irritation. Wash after skin
contact. Wear safety goggles/glasses
when using. Avoid contact with eyes
or skin. If sealant contacts eyes,
flush
eyes
with
water
and
get
immediate medical attention.
a.
Apply pipe sealant to threads of fuel pressure
transmitter (50). Install and tighten fuel pressure
transmitter in mating tee.
b.
Apply pipe sealant to male pipe threads of fuel
hose (52) and elbow (54).
c.
Install fuel filter differential pressure switch (51)
in bench vise. Install male end of fuel hose (52)
and elbow (54) into pressure switch. Elbow is
installed in end with wire leads.
d.
Install fuel filter differential pressure switch (51)
on mating bracket with tie wraps.
Hydraulic fitting sealant can cause
eye damage or skin irritation. Wash
after skin contact. Wear safety
goggles/glasses when using. Avoid
contact with eyes or skin. If sealant
contacts eyes, flush eyes with water
and get immediate medical attention.
e.
Apply hydraulic fitting sealant to exposed threads
of swivel tee at fuel filter and threads of elbow
(54).
f.
Install and tighten female end of fuel hose (52) to
mating swivel tee and fuel hose (53) to elbow
(54).
g.
Apply
electrical
insulating
compound
to
connector plug of fuel pressure transmitter and
fuel filter differential pressure switch (50 and 51).
h.
Plug connector plugs of fuel pressure transmitter
and fuel filter differential pressure switch (50 and
51) into mating DCA harness connectors.
i.
Remove machinery wiping towels. If saturated,
dispose of towels in accordance with local
procedures.
GO TO NEXT PAGE
7-131
