TM 5-3895-373-20 7.17. REPLACE DCA AND PRESSURE TRANSMITTERS - Continued. B. INSTALL Continued. 5. INSTALL OIL PRESSURE TRANSMITTER AND OIL      FILTER      DIFFERENTIAL      PRESSURE TRANSMITTER. Thread    locking    compound    solvent can  cause  eye  damage.    Wear  safety goggles/glasses  when  using.    Avoid contact with eyes.  If solvent contacts eyes,  flush  eyes  with  water  and  get immediate medical attention. a. Clean   hex   head   cap   screws   (46)   with   thread locking    compound    solvent.        Wipe    dry    with cleaning cloth. b. Clean threads of elbow (48) and straight adapter (49) with cleaning cloth. c. Install flat washers (47) on hex head cap screws (46). Thread locking  compound  can  cause eye damage. Wear safety goggles/glasses  when  using.    Avoid contact    with    eyes.        If    compound contacts  eyes,  flush  eyes  with  water and get immediate medical attention. d. Apply thread locking compound to threads of hex head cap screws (46). e. Install   oil   filter   differential   pressure   transmitter (43)  with  flat  washers  (47)  and  hex  head  cap screws (46).  Tighten hex head cap screws. Pipe  sealant  can  cause  eye  damage or   skin   irritation.      Wash   after   skin contact.  Wear safety goggles/glasses when using.  Avoid contact with eyes or   skin.      If   sealant   contacts   eyes, flush eyes with water and get immediate medical attention. f. Apply  pipe  sealant  to  threads  of  elbow  (48)  and straight adapter (49). g. Install elbow (48) and straight adapter (49) in oil filter differential pressure transmitter (43).  Open end of elbow should aim straight out from paving machine. h. Install and tighten hose (44) on elbow (48). i. Install  and  tighten  hose  (45)  on  straight  adapter (49).        Hold    straight    adapter    with    a    backup wrench. j. Apply   pipe   sealant   to   threads   of   oil   pressure transmitter  (42).    Install  and  tighten  oil  pressure transmitter. k. Apply electrical insulating compound to connector plugs of pressure transmitters (42 and 43). l. Plug   connector   plugs   of   pressure   transmitters (42 and 43) into mating DCA harness connectors. m.    Remove  machinery  wiping  towel.    If  saturated, dispose    of    towels    in    accordance    with    local procedures. GO TO NEXT PAGE 7-130