7.12. REPLACE/REPAIR WORK LIGHTS

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
745

TM 5-3895-373-20 7.12. REPLACE/REPAIR WORK LIGHTS. This task covers: a. Remove b. Repair c. Install INITIAL SETUP Tools: Materials/Parts: General mechanic’s automotive tool kit Electrical insulating compound (Item 11, Appendix C) (Item 54, Appendix E) Bulb Electrical connector repair kit (Item 53, Appendix E) Self-locking nuts Solder (Item 47, Appendix E) Wire terminals Soldering iron (Item 23, Appendix E) Self-locking hex nuts References: TM 5-3895-373-24P NOTE There are three left hand work lights and three right hand work lights on the paving machine. This procedure refers to replacement and repair of right hand work lights. Procedure is identical for left hand work lights. Right hand work lights are shown in this procedure. A. REMOVE. 1. DISCONNECT WORK LIGHT (1, 2, OR 3) AT CONNECTOR (4). 2. REMOVE HEX HEAD CAP SCREW (5) AND SELF-LOCKING NUT (6). REMOVE WORK LIGHT FROM MOUNTING BRACKET (7). DISCARD SELF-LOCKING NUTS. 3. FOR REAR (1) AND AUGER (2) WORK LIGHTS, REMOVE MACHINE SCREW (8) AND MOUNTING BRACKET (7). FOR FORWARD (3) WORK LIGHTS, REMOVE MACHINE SCREW (8), SELF-LOCKING HEX NUT (9), AND MOUNTING BRACKET (7). DISCARD SELF-LOCKING HEX NUT. GO TO NEXT PAGE 7-103

Privacy Statement
Press Release
Contact