1. DISCONNECT BATTERY CABLES

7.6. REPAIR/REPLACE OPERATOR CONTROL CONSOLE ASSEMBLY

2. DISCONNECT ELECTRICAL CONNECTORS AND REMOVE HARNESS CLAMP, HARNESS SUPPORT ANGLE, AND CONDUIT MOUNTING FLANGE FROM FRONT PLATE

TM-5-3895-373-20 Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
666

TM 5-3895-373-20 7.6. REPAIR/REPLACE OPERATOR CONTROL CONSOLE ASSEMBLY - Continued. A. REMOVE. 1. DISCONNECT BATTERY CABLES. a. Unbuckle battery box holddown straps (1) and remove battery box covers (2) from both batteries. b. Remove rubber battery terminal covers (3) from battery terminals. WARNING When disconnecting batteries, disconnect negative battery cable before disconnecting positive battery cable. Failure to disconnect batteries in the proper sequence may lead to electrical shock or short circuit and result in personnel injury. c. Remove battery nut (4) and negative battery cable (5) from negative terminal of outboard battery. d. Remove battery nut (4) and positive battery cable (6) from positive terminal of inboard battery. e. Set negative battery cable (5) and positive battery cable (6) aside where the cables are unable to contact battery terminals. GO TO NEXT PAGE 7-24

Privacy Statement
Press Release
Contact