TM 5-3895-373-20
7.6.
REPAIR/REPLACE OPERATOR CONTROL CONSOLE ASSEMBLY.
This task covers:
a.
Remove b.
Clean c.
Install
INITIAL SETUP
Tools:
General mechanic’s automotive tool kit
(Item 54, Appendix E)
Bushing press tool (Item 1, Appendix D)
Hex head driver socket (Item 43, Appendix E)
Hex head driver socket (Item 44, Appendix E)
Slide hammer puller (Item 32, Appendix E)
Torque wrench (Item 68, Appendix E)
Wire scratch brush (Item 6, Appendix E)
Materials/Parts:
Adhesive (Item 3, Appendix C)
Cleaning cloth (Item 7, Appendix C)
Cleaning solvent (Item 24, Appendix C)
Electrical insulating compound (Item 11,
Appendix C)
Electrical insulating varnish (Item 32,
Appendix C)
Lint-free cloth (Item 8, Appendix C)
Tags (Item 22, Appendix C)
Thread locking compound (Item 12,
Appendix C)
Thread locking compound solvent (Item 25,
Appendix C)
Tie wraps (Item 29, Appendix C)
Cover plate seal
Door seals
Lockwashers
Panel seals
Self-locking hex nuts
Self-locking nuts
Self-locking screws
Sleeve bushings
Personnel Required:
Three 62B construction equipment repairers.
Two extra persons
to assist with removing and installing operator
control console.
References:
TM 5-3895-373-10
TM 5-3895-373-24P
Equipment Condition:
Center top right access door open per TM 5-
3895-373-10.
Center top left access door open per TM 5-
3895-373-10.
Operator control console protective cover
removed and stowed
per TM 5-3895-373-10.
Rear top left access door open per TM 5-
3895-373-10.
GO TO NEXT PAGE
7-23
