TM 5-3895-373-205.2. REPLACE EXHAUST MUFFLER AND PIPES - Continued.A. REMOVE Continued.d.Remove nuts (21) and washers (22) securingexhaust pipe (20) to exhaust elbow (23).Do not allow pieces of the gasket to fallinto the exhaust elbow. Gasket materialin the engine can destroy the engine orlead to engine failure. If material doesfall into the exhaust elbow and cannot beremoved, notify next higher levelmaintenance immediately.e.Lift exhaust pipe (20) off exhaust elbow studsand remove through engine compartment.Discard exhaust pipe.f.Remove and discard gasket (24).B. INSTALL.1.INSTALL EXHAUST PIPE.Use caution when scraping gasketmaterial from exhaust elbow. Do notscratch or gouge exhaust elbowsealing surface when scraping gasketmaterial. Poor sealing and carbonmonoxide leakage may result fromscratches or gouges in exhaustelbow sealing surface.a. Use putty knife to remove all gasket material fromexhaust elbow (23).b. Place gasket (24) over studs on exhaust elbow (23).flush eyes with water and get immediate medicalattention.c. Install exhaust pipe (20) over studs on exhaust elbow(23). Ensure gasket (24) and exhaust pipe end arealigned together correctly.Anti-seize compound can cause eyedamage. Wear safetygoggles/glasses when using. Avoidcontact with eyes. If compoundcontacts eyes,flush eyes with waterand get immediate medical attention.d. Coat exhaust elbow stud threads with anti-seizecompound and install washers (22) and nuts (21).Tighten to 45 lb-ft (61 N•m).GO TO NEXT PAGE5-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
