TM 5-3895-373-20
2.23.9. REPLACE HYDRAULIC CHARGE FILTER ELEMENT.
This task covers:
a.
Remove
b.
Install
INITIAL SETUP
Tools:
References:
General mechanic’s automotive tool kit
TM 5-3895-373-10
(Item 54, Appendix E)
TM 5-3895-373-24P
Drip pan (Item 28, Appendix E)
O-ring tool (Item 52, Appendix E)
Equipment Condition:
Torque wrench (Item 68, Appendix E)
Right access door open per TM 5-3895-373-10.
Materials/Parts:
Cleaning solvent (Item 24, Appendix C)
Hydraulic oil (Item 18, Appendix C)
Lint free cloth (Item 8, Appendix C)
Machinery wiping towel (Item 30, Appendix C)
Hydraulic charge filter element
O-rings
NOTE
This procedure refers to a single
hydraulic charge filter. The paving
machine uses two filters. This
procedure
should
be
used,
as
needed, to replace either or both
charge filters.
A.
REMOVE.
WARNING
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
HI cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
1.
CLEAN OUTSIDE SURFACE OF HYDRAULIC
CHARGE FILTER ASSEMBLIES (1) USING CLEANING
SOLVENT AND LINT-FREE CLOTH.
GO TO NEXT PAGE
2-422
