TM 5-3895-373-20B. REPAIR Continued.3. ASSEMBLE CONNECTOR.a. Slide connector body (33) and threaded retainerring (35) onto the end of coil cord (28).b. Slide a piece of spiral wrap (32) 2 in. (50,8 mm)long onto the end of coil cord (28).c. Insert wires through plastic seal (36) and rubbergrommet (37).d. Solder one wire to each of the four terminals onthe back of pin coupling (34) in accordance withMILSTD-2000. Ensure that the opposite end ofeach wire is tagged with terminal screw (29)position at front body (21) for use duringinstallation.e. Press rubber grommet (37) down onto the solderconnections on pin coupling (34).f. Align the guide tooth on plastic seal (36) withthe groove on pin coupling (34) and securerubber grommet (37) in place.g. Slide threaded retainer ring (35) onto pincoupling (34).h. Install connector body (33) onto pin coupling(34).i. Slide spiral wrap (32) inside of connector body(33) and heat with a heat gun until securely inplace.j. Install clamp assembly (31) onto connector body(33) and secure wiring in place with machinescrews (30).GO TO NEXT PAGE15-121
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
