TM 5-3895-373-10 d. Jog  left  or  right  feeder  control  switch  up,  ON, and    down,    OFF,    to    maintain    proper    paving material  level  in  the  auger  chamber.    Depth  of paving material should be maintained at one half to    three    quarters    the    height    of    the    auger diameter. NOTE If reverse operation of the auger/conveyor  system  is  desired  in the   manual   mode,   with   the   auger/ conveyor    switch     on     the     operator control  console   in   manual,   turn   the feeder  control  switch  on  the  screed control     panel     off     and     place     the auger/conveyor reverse control switch in the up, ON, position. e. Place     the     auger/conveyor     switch     in     down, "MAN", position then the auger/conveyor reverse control  switch  in  the  up,  REVERSE,  position  if auger/conveyor  manual  operation  in  reverse  is desired. Auger/conveyor reverse control switches    are    located    on    both    left    and    right screed control panels only. 2.14.2 Automatic Operation. a. Turn left and right auger/conveyor speed control valves   fully   clockwise   and   then   back-off   the valve  three  clicks.    This  is  done  to  balance  out auger/conveyor speed at the start of paving.  To further adjust the speed of left or right auger/conveyor  systems  turn  the  speed  control valve  counterclockwise  to   increase   speed   and clockwise to decrease speed. NOTE If reverse operation of the auger/conveyor  system  is  desired  in the   manual   mode,   with   the   auger/ conveyor    switch     on     the     operator control  console   in   manual,   turn   the auger/conveyor  switch  on  the  screed control panel off and place the auger/ conveyor   reverse   control   switch   in the up, ON, position. b. Place  left  and  right  auger/conveyor  switches  on operator   control   console   switch   panel   to   up, AUTO position. c. Place left and right feeder control switches in the up,  ON,  position  on  both  screed  control  panels. Ensure the auger/conveyor indicator lights on the gauge panel are on. d. If the automatic control is not maintaining proper level  in  the  auger  chamber,  raise  or  lower  flow gates,  increase  or  decrease  the   speed   of   the auger/conveyor systems by adjusting the auger/conveyor  speed  control  valve,  or,  adjust the feed limit switch paddle. 2-39