TM 5-3895-373-10g.Place auger/conveyor switches in center, OFFposition.WARNINGDo not open the screed travel lockvalve if anyone is near or under thescreed. The screed can fall rapidlywhen the screed travel lock valve isopened. Falling screed can causesevere injury or death.h.If screed is in travel position, use caution andopen the screed travel lock valve, refer toparagraph 2.1.4.i.Place screed lift switch to down, FLOAT position,to lower the screed until the screed rests on theground.j.Place the throttle control switch in "IDLE"position. Idle the engine for one minute to allowthe engine to cool.k.Place the ignition switch to the STOP position.l.If shutdown follows paving operations, refer tofuel spray washdown system operation perparagraph 3.3.7.NOTEProtective covers are provided withbrackets for the installation ofpadlocks.m.Remove the operator control consoleprotective cover from the stowage locationon the front top right access door.n.Install the protective cover on the operatorcontrol console. Slide the cover over theconsole so the control handles fit in theopen slot on the cover.o.Remove the screed crew control boxprotective covers from the stowagelocation on top of the control boxes.p.Install the protective covers on the screedcrew control boxes by sliding the hinge onthe cover over the hinge pin on the box.Close the protective covers.2-34
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business