TM 5-3895-371-24 & P
with new transmission oil allowing a small excess oil to spill over the face of the block assembly (30).
utilizing reference marks in housing and cover. To operate properly, the cover must be assembled in
its original position. Install two short capscrews (35, fig. 3-4), four long capscrews (19), and six lock-
washers (20). Torque capscrews opposite one another to 40 Ib-ft (54 Nm) until all six capscrews are
tight.
Figure 3-45. Installing Pump Cover.
(26)
Position bearing (13). Lubricate the entire charge pump cavity with clean transmission
oil.
pump shaft (53).
Figure 3-46. Charge Pump Lower Valve Plate.
3-40
