Section I - INTRODUCTION
A. PURPOSE OF MANUAL
This manual has been prepared to assist the users of Vickers balanced vane type hydraulic single pumps in properly
installing, maintaining and repairing their units. In the sections which follow, the single pumps are described in detail,
their theory of operation is discussed and instructions are given for their proper installation, maintenance and overhaul.
The general series of models covered are V100, V200, V300, V400, V500 and V2P. The information given applies to
the latest design configurations listed in Table I. Earlier designs are covered only insofar as they are similar to the
present equipment.
B. GENERAL INFORMATION
1. Related Publications - Service parts information and installation dimensions are not contained in this manual.
The parts catalogs and installation drawings listed in Table I are available from any Vickers Mobile Division Application
Engineering office, or from:
Vickers
Mobile Hydraulics Division
Product Service Department
P.O. Box 302, Troy, Michigan
2. Model Codes - There are many variations within each basic model series, which are covered by variables in the
model code. Table II is a complete breakdown of the code covering these units. Service inquiries should always include
the complete unit model number, which is stamped on the pump cover.
TABLE I
PARTS CATALOGS AND INSTALLATION DRAWINGS
MODEL
DESIGN NO.
PARTS
INSTALLATION
SERIES
(See Table II)
CATALOG
DRAWING
V100
-10
M-2031-S
M-152060
V200
-12
M-1771-S
M-190082
V300
-11
M-2033-S
M-128797
V400
M-127065
V500
-10
M-1262-S
M-236696
V2P
-10
M-2002-S
M-289405
Figure 1
2
