TM 5-3895-385-23-2
0338
Fuel Injector Installation -- Continued.
5. Install rounded edge of injector fastening clamp (Figure 3, Item 2) over fuel injector (Figure 3, Item 3), and
install two injector clamp bolts (Figure 3, Item 1) into injector fastening clamp finger-tight.
6. Install high-pressure fuel connector (Figure 4, Item 3) through high-pressure fuel connector inlet (not shown)
and into injector high-pressure connector port (Figure 4, Item 1), and install retaining nut (Figure 1, Item 3)
onto high-pressure fuel connector finger-tight.
7. Torque retaining nut (Figure 1, Item 3) to 133 inch-pounds (in-lb) (15 Newton meters (Nm)).
CAUTION
Injector fastening clamp bolts must be tightened evenly. Ensure the gap between the clamp and
the fuel injector is evenly spaced around the entire fuel injector body. Failure to comply may
cause damage to equipment.
8. Torque injector clamp bolts (Figure 3, Item 1) alternately to 71 in-lb (8 Nm).
9. Torque retaining nut (Figure 1, Item 3) to 37 foot-pounds (ft-lb) (50 Nm).
0338-6