TM 5-3895-385-23-1
0182
Table 1. Output Module Offline Fault Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. No power to output module.
1. Turn keyless engine switch to
the AUX position (TM 5-3895-
385-10), but do not start engine.
2. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
Volts Direct Current (VDC),
W1 J39 Pin 1 and W1 J3 Pin 10
proceed to next test.
(WP 0451, Vol 3, Figure 1).
2. If voltage reads below 22 VDC,
turn keyless engine switch to the
OFF position (TM 5-3895-385-
10), and proceed to next
malfunction.
3. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
VDC, proceed to next test.
W1 J39 Pin 1 and W1 J3 Pin 12
(WP 0451, Vol 3, Figure 1).
2. If voltage reads below 22 VDC,
turn keyless engine switch to
the OFF position (TM 5-3895-
385-10), and replace main
wiring harness (WP 0373, Vol
2).
4. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
VDC, proceed to next test.
W1 J39 Pin 1 and W1 J3 Pin 11
(WP 0451, Vol 3, Figure 1).
2. If voltage reads below 22 VDC,
turn keyless engine switch to
the OFF position (TM 5-3895-
385-10), and replace main
wiring harness (WP 0373, Vol
2).
5. Measure voltage (WP 0443, Vol
1. If voltage reads a minimum of 22
3) between main wiring harness
VDC, turn keyless engine switch
W1 J39 Pin 1 and W1 J39 Pin 2
to the OFF position (TM 5-3895-
(WP 0451, Vol 3, Figure 1).
385-10), and proceed to
malfunction 6.
0182-2
