TM 5-3895-373-34
A.
REMOVE.
1.
REMOVE DRIVE SHAFT, BEARING UNITS, AND
SPROCKET WHEELS AS AN ASSEMBLY.
a.
Remove hex head cap screws (1), lockwashers
(2), and clamps (3) from lubrication lines (4) at
inner and outer bearing units (5 and 6). Discard
lockwashers.
b.
Loosen but do not remove set screws (7 and 8).
c.
Remove hex head cap screws (9) and flat
washers (10) from inner bearing unit (5).
d.
Remove hex head cap screws (11) and flat
washers (12) from bearing plate (13).
e.
Remove hex nuts (14), flat washers (15), hex
head cap screws (16), and flat washers (17)
from outer bearing unit (6).
f.
With the help of a second person, push the inner
end of drive shaft (18) into the auger/conveyor
drive chain well and slide the outer end of the
drive shaft toward the back of the paving
machine. Remove the assembled conveyor
drive shaft, sprocket wheels (19), inner and outer
bearing units (5 and 6), bearing plate (13), and
sprocket wheel (20) from the paving machine.
GO TO NEXT PAGE
2-873
