TM 5-3895-373-34
2.63
REPLACE AND ADJUST AUGER/CONVEYOR DRIVE CHAIN - Continued.
E.
INSTALL - Continued.
3.
INSTALL CENTER COVER.
a.
Install flat washers (11) onto hex head cap
screws (10).
Thread locking compound can cause
eye
damage.
Wear
safety
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
b.
Apply thread locking compound to threads
of hex head cap screws (10) and socket
head cap screws (13).
c.
Align holes of center cover (12) with holes
on the paving machine.
d.
Close left rear top access door and open
right rear top access door and install socket
head cap screw (13), flat washer (14), and
hex nut (15) into left side of center cover
(12).
e.
Open left rear top access door and close
right rear top access door and install socket
head cap screw (13), flat washer (14), and
hex nut (15) into right side of center cover
(12).
f.
Open left rear top access door.
g.
Install hex head cap screw (10) with flat
washer (11) into center cover (12).
h.
Tighten hex nuts (15) and hex head cap
screws (10) to 37 lb-ft (50 N•m).
i.
Lubricate auger/conveyor drive chain in
accordance with LO 5-3895-373-12.
GO TO NEXT PAGE
2-870
