TM 5-3895-373-34
2.64
REPLACE/REPAIR CONVEYOR DRIVE SHAFT, BEARING UNITS, AND SPROCKET WHEELS.
This task covers:
a.
Remove
b.
Clean
c.
Inspect
d.
Install
INITIAL SETUP
Tools:
Personnel Required:
General mechanic’s automotive tool kit
Two 62B construction equipment repairers. Second person to
(Item 106, Appendix D)
support sprocket wheels and shaft during removal and
Hex head driver socket (Item 84, Appendix D)
installation.
Level and plumb, 2 ea (Item 54, Appendix D)
Sledge hammer (Item 48, Appendix D)
References:
Torque wrench, 0 to 175 Ib-ft (Item 132, Appendix D)
LO 5-3895-373-12
Torque wrench, 0 to 300 lb-in (Item 131, Appendix D)
TM 5-3895-373-20
Wire scratch brush (Item 13, Appendix D)
TM 5-3895-373-24P
Materials/Parts:
Equipment Condition:
Cleaning cloth (Item 6, Appendix B)
Screed removed per TM 5-3895-373-20.
Cleaning solvent (Item 31, Appendix B)
Conveyor chain assembly removed per paragraph 2.61.
Grease (Item 18, Appendix B)
Auger/conveyor drive chain removed per paragraph 2.63.
Thread locking compound (Item 13, Appendix B)
Thread locking compound solvent (Item 32, Appendix B)
NOTE
Lockwashers
Remove the auger/conveyor drive chain only on
the side that is being worked on.
NOTE
There is both a right hand and left hand set of
conveyor bearing units, drive shafts, and sprocket
wheels on the paving machine. This procedure
refers to replacement of the right hand conveyor
bearing units, drive shafts, and sprocket wheels.
The procedure is identical for the left side. The
right hand side is shown in this procedure.
GO TO NEXT PAGE
2-872
