TM 5-3895-373-34
2.55
REPLACE VALVE PANEL CONTROL VALVES AND FLOW DIVIDERS - Continued.
C.
INSTALL - Continued.
NOTE
If both ends of tube (128) were loosened
during removal, both must be tightened
after installation.
f.
Connect tubes (127 and 128) to elbows (129 and
130). Tighten tubes.
g.
Connect hoses (131 and 132) to straight
adapters (133 and 134). Tighten hoses.
h.
Apply electrical insulating compound to male
ends of auger/conveyor control valve electrical
connectors (123 and 124). Plug control valve
electrical connectors into harness electrical
connectors (125 and 126).
GO TO NEXT PAGE
2-774
