TM 5-3895-373-34
D.
ASSEMBLE.
NOTE
Use bench vise, as required, to
support
tow
point
control
valve
during assembly.
1.
INSTALL POPPET, SPRING, ADJUSTMENT
SCREW, AND VALVE CAP NUT ONTO INLET
MANIFOLD.
Hydraulic
oil
can
be
moderately
flammable and can be an irritant to
the
skin,
eyes,
and
respiratory
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
hydraulic oil.
a.
Coat all parts with clean hydraulic oil. Do
not dry. Place on a clean, lint-free cloth.
b.
Install preformed packing (36) into inlet
manifold (13).
c.
Install seat (35) with counter bore side out.
d.
Install and tighten retainer (34) using an
alien wrench.
e.
Install poppet (33) and spring (32) into inlet
manifold (13).
Be careful not to damage preformed
packing when sliding over threads.
Sharp edges of threads can cut or
damage
preformed
packing.
Damaged
preformed
packing
will
cause
leakage
and
affect
performance.
f.
Install preformed packing (31), adjustment
screw (29), and self-locking hex nut (30)
into inlet manifold (13).
g.
Install preformed packing (28) and valve
cap nut (27) onto inlet manifold (13).
GO TO NEXT PAGE
2-639
