TM 5-3895-373-34
B.
CLEAN.
Cleaning solvent, P-D-680, is TOXIC and
flammable. Wear protective goggles and
gloves. Use only in a well ventilated area.
Avoid contact with skin, eyes, and clothes,
and do not breathe vapors. Keep away from
heat or flame. Never smoke when using
solvent; the flashpoint for Type m cleaning
solvent is 200°F (93,3°C). Failure to do so
may result in injury or death to personnel.
If personnel become dizzy while using
cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or
clothes, flush with cold water. If solvent
contacts eyes, flush eyes with water and get
immediate medical attention.
1.
RINSE ALL METAL PARTS IN CLEANING
SOLVENT.
Compressed air used for cleaning purposes
will not exceed 30 psi (207 kPa). Use only
with effective chip guarding and personal
protective equipment (goggles/face shield
and gloves). Failure to take proper
precautions may result in severe injury or
loss of vision.
2.
USE
30
PSI
(207
kPa)
MAXIMUM
COMPRESSED
AIR
TO
REMOVE
ANY
FOREIGN MATTER FROM VALVE BODY,
THREADED SURFACES, BORES, AND SEAL
GROOVES.
3.
FLUSH
VALVE
BODY
WITH
CLEANING
SOLVENT
TO
REMOVE
ANY
FOREIGN
MATERIAL PRESENT. USE A CULTURE
SWAB TO REMOVE FOREIGN MATERIAL
FROM VALVE BODY INNER BORE.
4.
FLUSH
INLET
MANIFOLD
BODY
WITH
CLEANING
SOLVENT
TO
REMOVE
ANY
FOREIGN MATERIAL PRESENT. USE A
CULTURE
SWAB
TO
REMOVE
ANY
MATERIAL FROM INLET MANIFOLD INNER
BORE.
GO TO NEXT PAGE
2-635
