TM 5-3895-373-34
2.46
REPAIR TOW POINT CONTROL VALVE - Continued.
D.
ASSEMBLE - Continued.
2.
INSTALL SPOOL, TUBE ASSEMBLIES, AND
ELECTRICAL COILS ONTO VALVE BODY.
Hydraulic oil can be moderately flammable
and can be an irritant to the skin, eyes, and
respiratory system. Avoid prolonged expos-
ure. Eye protection and rubber gloves must
be worn when working with hydraulic oil.
Do not drop spool or allow it to scrape
across threads in valve body. Handle spool
with care. Damage to surface of spool can
prevent it from working properly.
a.
Dip spool (26) and valve body (15) into
clean hydraulic oil. Install spool into valve
body. Ensure spool is oriented correctly.
b.
Install spring retainers (25) and springs (24)
onto spool inside valve body.
c.
Install tube assemblies (23) onto valve body
(15). With crowfoot wrench at 90° to torque
wrench, tighten tube assemblies to 35 Ib-ft
(48 N•m).
d.
Slide electrical coils (22) onto tube
assemblies (23).
Thread locking compound can cause eye
damage. Wear safety goggles/glasses when
using.
Avoid
contact
with
eyes.
If
compound contacts eyes, flush eyes with
water and get immediate medical attention.
e.
Apply thread locking compound to threads
of tube assemblies (23).
f.
Install hex nuts (21) onto tube assemblies
(23). Tighten hex nuts to 12 lb-in (1,4
N•m).
GO TO NEXT PAGE
2-640
