TM 5-3895-373-34
A.
DISASSEMBLE - Continued.
3.
REMOVE THREADED END RODS, OUTLET
AND INLET MANIFOLDS, AND LOCK VALVE
FROM TOW POINT CONTROL VALVE.
a.
Remove hex nut (10), flat washers (11), and
threaded end rods (12) from tow point
control valve.
b.
Separate inlet manifold (13) and outlet
manifold (14) from valve body (15).
c.
Remove preformed packings (16) from inlet
manifold (13) and from outlet side of valve
body (15). Discard preformed packings.
d.
Remove socket head cap screws (17) and
lockwashers (18) from lock valve (19).
Discard lockwashers.
e.
Remove lock valve (19) from valve body
(15).
f.
Remove preformed packings (20) from lock
valve (19). Discard preformed packings.
4.
REMOVE
ELECTRICAL
COILS,
TUBE
ASSEMBLIES, AND SPOOL FROM VALVE
BODY.
a.
Remove hex nuts (21) from electrical coils
(22).
b.
Slide
electrical
coils
(22)
from
tube
assemblies (23).
NOTE
Spring and spring retainer may fall
from
valve
body
after
tube
assemblies are removed.
c.
Remove tube assemblies (23) from valve
body (15).
d.
Remove spring (24) and spring retainer (25)
from valve body (15).
Do not drop spool or allow it to
scrape across threads in valve body.
Handle spool with care. Damage to
surface of spool can prevent it from
working properly.
e.
Note orientation of spool on removal for
proper installation. Remove spool (26)
from valve body (15).
GO TO NEXT PAGE
2-633
