TM 5-3895-373-34
2.37.
REPLACE TRACK TENSIONING CYLINDER - Continued
A.
REMOVE - Continued.
3.
REMOVE ELBOW AND PIPE BUSHING FROM
CYLINDER.
Do not clamp cylinder against metal jaws in vise. Use
wooden blocks between vise jaws and cylinder. Damage
to surface of cylinder can result from contact with metal
vise jaws.
a.
Clamp cylinder in a bench vise. Pad vise jaws
with wooden blocks.
b.
Remove elbow (6) and pipe bushing (7).
B.
INSTALL.
1.
INSTALL
PIPE
BUSHING
AND
ELBOW
ON
CYLINDER.
a.
Clamp cylinder in a bench vise. Pad vise jaws
with wooden blocks.
Pipe sealant can cause eye damage or
skin irritation. Wash after skin contact.
Wear
safety
goggles/glasses
when
using. Avoid contact with eyes or skin.
If sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention.
b.
Apply pipe sealant to threads of pipe bushing
(7) and install.
c.
Apply pipe sealant to threads of elbow (6) that
will be installed into pipe bushing (7).
d.
Install elbow (6) into pipe bushing (7). Tighten
elbow. Elbow must point in direction shown at
right.
e.
Remove
cylinder
from
bench
vise.
GO TO NEXT PAGE
2-516
