TM 5-3895-373-34
B.
DISASSEMBLE - Continued.
6.
REMOVE
CYLINDER
BLOCK
FROM
MECHANICAL DRIVE HOUSING.
a.
Install a bearing puller from universal puller kit
using two hex head cap screws (Item 27,
Appendix D).
b.
Compress spring (62) in cylinder block (63) with
bearing puller.
Use care when removing snap and retaining
rings. Snap and retaining rings are under spring
tension and can act as projectiles when released
and could cause severe eye injury.
c.
Use snap ring pliers to remove retaining ring (64)
from cylinder block (63).
Use care when releasing spring pressure.
Spring could fly out and cause injury.
d.
Slowly release pressure on spring (62).
e.
Remove bearing puller and hex head cap
screws.
NOTE
Shims (65) may be installed underneath ring
spacer (66) at the factory to obtain correct
cylinder block projection.
f.
Remove spring (62) and ring spacer (66).
Remove shims (65) if present.
g.
Lift cylinder block (63) straight out of mechanical
drive housing (48).
h.
Use snap ring pliers to remove retaining ring (64)
from cylinder block (63).
i.
Remove shaft (67).
GO TO NEXT PAGE
2-449
